DIY: How to wire Euro Bumper turn signals

[Butler]

The euro bumper turn signals have a two pin connector, while the american spec uses a three pin connector. The third pin allows for a dual filament bulb.

The answer is pretty simple. I just cut, bent, chewed off the parking like connection on the american plastic plug.

Needed:
needle nose pliers
utility knife
electrical tape


Here is how:



The stock american three pic connector -



I carefully chipped away at the connector until I had the third pin free from the ground and turn signal pins. The parking light is the grey wire on both sides. Leaving the brown (ground) and the blue/red (blinker) intact.




You may have to cut away at the edges until it fits into the turn signal plug. Really though, it shouldnt take much. I had mine first try and it fit nice and snug.

Euro 2 pin connector.






Well there you have it. Plug n play.

[Aptyp]

This post is underrated and proof that a search function works.

[efficient]

I did this the only downside is that your day lights don't work only when the clicker is on.