If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Sorry to add to a very old thread but just thought I would add for anyone who might not be able to figure out what to use for the ICV side, I bought a 21/32 drill bit, m18x1.5 tap and m18x1.5 male to 19an male fittings with a female 10an to whatever barb size you desire, I picked 5/8 as the hose ID was about .68in I believe.
I tried this out, but it doesn’t seem possible. There is not enough room for an elbow or anything after the m18x1.5 to 10an!
Comment