Just came up with an idea of making my own smoke side marker lights without the ugly paint.
1- Remove the bulb out, using a screwdriver try to push out the reflector out, most likely the reflector will crack or brake, try to remove it without braking the housing (no problem you will not need it), clean out all of it until all you have its just the housing it should look like this one.
2- Find a used set of tail light like the one below, carefully remove the outer lens without braking the smoked section, underneath you will find a smooth yellow reflector and a red one as well.
3- Cut 2 yellow and 2 red rectangles to be fitted in the original housing.
4- Cut four smoke rectangle the same size to be fitted in the same housing.
By placing the yellow and the red reflector under the smoke one it will give you yellow for front and red for the rear.
I used automotive Goop to glue it together, forgot to take pics of it lit up.
Here are the yellow one powered up, red still searching for smooth red plastic.
1- Remove the bulb out, using a screwdriver try to push out the reflector out, most likely the reflector will crack or brake, try to remove it without braking the housing (no problem you will not need it), clean out all of it until all you have its just the housing it should look like this one.
2- Find a used set of tail light like the one below, carefully remove the outer lens without braking the smoked section, underneath you will find a smooth yellow reflector and a red one as well.
3- Cut 2 yellow and 2 red rectangles to be fitted in the original housing.
4- Cut four smoke rectangle the same size to be fitted in the same housing.
By placing the yellow and the red reflector under the smoke one it will give you yellow for front and red for the rear.
I used automotive Goop to glue it together, forgot to take pics of it lit up.
Here are the yellow one powered up, red still searching for smooth red plastic.
Comment