Can you change the idle map to match the stock tune's idle map ?
My war stuff uses an x5 v8 maf & the miller idle was very fat. Eventually, the idle got much better leaning it out with the wideband o2 sensor. I ended up using a measured idle hose after going through 3 new idle control valves that the war chip couldn't control. Brody's 535 doesn't have an idle control valve either. Surprised idle works on any war stuff.
-
HELP WITH IDLE WAR chip tunes.
Ok so I have been chasing this problem. I just cant get the car inspected until it has a normalish idle. Right now I have and 1300 RPM idle.
I have replaced. ALL hoses intake boot. I have hose clamps on things that did not normally have them
I have a new IVC
New and working correctly TPS
If I run the tune Miller recommends me the car runs awsome but high idle. If I run a stock tune the car idles fine just wont run right. Runs lean.
So what can I adjust to help this issue? Total nood to tuning.
I have set the idle RPM super low but it is unresponsive.
Leave a comment: