Micorsquirt - Where to physically locate capacitors for d585 coils?

[thebutterson]

I've read the megamanual write up for using capacitors with the LS1 and LS2 ignition coils but haven't been able to find any data on where people are actually locating them with their microsquirt setup. I know most people here are using megasquirt which has places to put these on the board, but microsquirt is all encased and doesn't allow for this.

I was thinking of just getting a little project board from radioshack along with a case but was wondering if there are other solutions that may be a bit more tidy.

Also, if anyone has some suggestions on any special capacitors that may be required for automotive use I'd appreciate it.

[nando]

You don't really need them.

[thebutterson]

I've seen threads where people claimed it caused feedback problems with their microsquirt, is that not the case? Have you had good experience without them?