Help finding flanges (89 325is)

[KillaCams]

Hey guys, recently acquired a Remus muffler for my 89 325is, my setup now (built by previous owner) is a hack job, it consists of IE headers to welded to the stock downpipes into the stock cat, welded on the back of the cat is a Y pipe to a single pipe (2 1/4 i guess) to the exhaust. The Remus muffler is designed to bolt up to the stock setup, i really don't want to have a shop hack up the Remus to make this work, anyone have any ideas where i can get matching flanges that i can have welded onto my cat? Having a hard time finding them used, if it boils down to it i may just have to wait and get a high flow cat and have the whole exhaust system redone. Any help is greatly appreciated.

[White325is]

From the sounds of it, you need a whole new exhaust system. So I would suggest just doing that. ha.

[KillaCams]

I know i know, but i really want to get this muffler on. My neighbor is going to cut the y pipe off and weld the flanges on for me if i can get them. Even if i decide to get a high flow cat i would still need the flanges to make this be able to bolt on and off easily.

[KillaCams]

Bump, anyone got any ideas on this? Guess im on the hunt for a complete exhaust mid section

[einstein57]

There are tons of e30s with rusted mufflers. Just cut off the OEM muffler and weld on the factory pipes. Or just put a full 2.5" exhaust.

[KillaCams]

Just to update this in case anyone searches for the same information, i was able to get a used stock midsection replacement. I did find out though, that Pelican and many other parts places do carry replacement flanges.