If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I was looking to buy a Magnaflow 14815 muffler and I was wondering if I could just weld the muffler onto the pipes without having to buy anything else.
Should I get a silencer then? my neighbor has this muffler and I don't think he's had any problems with it. I dunno I really like it, I think I'm going to get it anyway hehe.
Loud indeed, I have a m10 with 2.5" piping header back to a single Vibrant (straight through muffler) and it's loud, very loud. At highway speeds, I have to yell at my passenger.
85' 318i ~The Bronze Bomber (FrankenM10 with a Forced Future :wgaf:)
To answer you question, yes it will work. I have one with a Magnaflow inline muffler were my resonator/cat used to be and it is loud in cabin but sonds good.
But i have a eta so im always in the drone
but its not to bad
I have this muffler on my convertible and it was welded straight on to the stock piping. I didn't really like the welding job. I'd recommend getting a Y pipe for a neater job.
The term loud is very different for some people. I have an 03 Cobra w/o cats and Borla Stingers that I consider to be pretty loud. I haven't had a muffler on my e30 though for over a year now w/o even a look from cops. It has some drone, but sounds fine in high revs so I have just left it like that until I finally got my custom exhaust made. If you have cats then it can't be too loud is my rule of thumb. ;)
Comment