The copper wire that came with the tool is not staying in the grooves. We've tried tapping it lightly with a rubber hammer but it wont stay in. And recommendations on what i can do to get it to stay in the block?
-
-
Your groove is too wide or too shallow, or your wire is too small. Did you check the tool to see if the business end is bunged up, making your groove wider than spec?"If the sky were to fall tomorrow, the tall would die first."
-Dr. Paul Forrester
Do I LOOK like I need a psychological evaluation??? -
get thicker wire? mcmaster has .041 and .043 stainless wire in 1/4lb spools.Comment
-
i went to home depot and got some copper wiring out of house wiring because my grooves ended up too big on the 2 blocks i didComment
Comment