I've been waiting for a nice manifold to show back up for me to move forward on my turbo build. Put me down on the interest list once you come up with something that you feel is ready for production.
Keep up the good work!
M20 turbo manifolds
Collapse
X
-
Sorry to say but I do believe jg technik has closed their doors. Temporary or permanent??
I don't know. Anyway I wanted to put that out there. If you are talking about the jg technik from branford CT.Leave a comment:
-
Ill buy one from you if you can make a top mount, single scroll, t3 flange, and 38mm vband wg provision for ~<$900Leave a comment:
-
I have the motor on the stand at my shop now so I will begin prototyping and figure the best turbo location for piping ex ..Leave a comment:
-
Ok ... Not top mount?... There are something's i done like about that manifold thoughLeave a comment:
-
I'd be interested in something like this for an m20. And since the spacing and port shape is the same as the s54 the R&D could easily be used on both engines.
Leave a comment:
-
Sorry I didn't mean to say you only did 24v manifolds, or to say what fabrication in general should be worth. I was just trying to say that i think largest market for m20 manifolds would be similar to your 24v and m30 manifolds.Leave a comment:
-
I just saw the one Otis custom made for my buddies e28. Nice piece!Leave a comment:
-
jg technick bought the jigs off 666 fab and I believe he sells the splitpulse mani for $1300 with dual vband wastegate provisions.Leave a comment:
-
This. Too bad I bought a egay turbo maniLeave a comment:
-
Your statement is incorrect, I make manifolds for the 24v in a E30,E34,E36. M30 in a E30,E34,E28,E24,E9. M42 E30. M10- E30,2002.Wow your fabrication is amazing and seeing that, definitely worth over over a grand. I guess I'm not a fabricator but I see Otis making manifolds (only 24v though) for cheaper, and there seems to be a larger market base for that in the e30 scene, not saying at all that you should sell manifolds that look like that for $750.
Best of luck, either way you'll sell a few if they're to the quality you posted above
Some are outsourced and some are custom fabricated in house.Last edited by Good & Tight; 12-08-2014, 04:25 PM.Leave a comment:
-
Wow your fabrication is amazing and seeing that, definitely worth over over a grand. I guess I'm not a fabricator but I see Otis making manifolds (only 24v though) for cheaper, and there seems to be a larger market base for that in the e30 scene, not saying at all that you should sell manifolds that look like that for $750.
Best of luck, either way you'll sell a few if they're to the quality you posted aboveLeave a comment:
-
I laughed so hard I pooped a little.....quality twins scrolls for under a grand, please....do share what you're smoking. If people think that $1500 is to much for this type of work you have ABSOLUTELY NO IDEA the amount of skill, effort equipment and consumable cost that goes into making something like this.
End rant-
Yours Truly,
Fellow Fabricator.
(When your hood drops the bullshit stops, rock on brotha)Leave a comment:

Leave a comment: