M20 turbo manifolds
Collapse
X
-
I'll throw in a second request for a TS that will work with an IX. I'd take one even if it was >1000. That seems to be what revshift and JG were charging for what was perceived to be a superior product.
Sent from my iPhone using TapatalkLeave a comment:
-
wow.. that's amazing fabrication !!!!
Sent from my iPhone using TapatalkLeave a comment:
-
-
I'm gonna try to have my car ready to be able to do some testing on the dynoLeave a comment:
-
Ok sounds good ... I probably make two versions or have options on what everyone needsLeave a comment:
-
If you make a TS manifold that's not $1600 I think you'd have a TON of interest. I know how much time goes into it, but once you have something solid worked out, do a group buy. I think $1200 would be a fair price point for a split pulse top mount as far as the consumer end is concerned, don't know if that's a possibility or not.Leave a comment:
-
Ok I'm not sure what turbo I'm going to have for mock up but I will try to leave room so it will fit different turbos... I'm going to go with a Borg Warner for mine so that's what I might useLeave a comment:
-
I'd say try and borrow a holset HX35 since that's what most m20 guys end up running.Leave a comment:
-
Ok sounds good....Bottom mount might be a pain to initially install but it makes everything else way easier to work on. Well, maybe not oil changes but a filter relocation kit solves that issue. I prefer a stealthy kit. I just want a manifold that flows better than my current log setup.
I am gonna try to get a turbo tomorrow for mock up this weekend ...
I have prior experience in r&d at a r35 and 370z shop and have helped design turbo kits that were then mass produce ... So I have experience is design and function and can also fabricate ... If possible if I find some local interest I want to dyno test some different designs ....the money thing is gonna be the deciding factor in production... I try to make a superior product and I don't want to lower my standards to make a buck ... At the end of the day I have to support my family so I can eat.... I will see what I can do to make everyone happy but know that these take about a week a piece from start to finish to make and a decent amount in consumables everything is fully back purged so I use a lot of gas and it ain't cheap... On that not I hope to have it mocked up this weekend and try to get a prototype mocked up.. I also need to source a head flange that meets my expectations ... If anyone is local and has some interest in one please pm meLeave a comment:
-
Bottom mount might be a pain to initially install but it makes everything else way easier to work on. Well, maybe not oil changes but a filter relocation kit solves that issue. I prefer a stealthy kit. I just want a manifold that flows better than my current log setup.Leave a comment:

Leave a comment: