I put a 325e crank pully on a 325i motor... will this hurt anything?
-
-
I'm not sure... But as long as they look identical then I don't see why not.1990 Alpinweiss 325i - secret 500whp buildOriginally posted by audiquattrot
2000 Audi S4 B5 Laser Red
1990 Nissan 240sx - Drift Missile
2006 CBR600RR
-
they look identical, but when i went to get the new belt for the fan and alternator it was too long... like the "e" pulley, where the belt sits was smaller. i went and got a smaller belt and it fits fine. I doubt that should have any negative affect. and they're both tooth'd so i guess it'd work. just wasnt too sureComment
-
The e has a smaller crank pulley and bigger water pump. The i has smaller water pump and bigger crank.Comment
-
so MR325, you think id be fine?Comment
-
Doesn't seem like a big deal as long as the pulley has the toothed wheel for the crank sensor and you found the right belt.Comment
-
cool deal! thanks guys!Comment
Comment