If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
the bit that i cut off the bar leveled the plate. it also brought it very much closer to the pan. i raised the engine after all that just to increase the distance between the plate and pan.
i still like this skidder setup a lot. kudos for a well thought out and well executed product.
*my only input for revision would be to make the straights of the uprights (of the bar) longer and to tighten the radius of the 90 degree bends. (to ease any adjustment to the height of the bash bar.)
That's kinda weird, the skid plate is designed to be level to start with. Thanks again for the feedback, Now I have some new ideas, so look for some changes in the near future.
Comment