If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
how do you adjust your ignition timing on a m20b25 i just swapped my motor and the timing is slightly off and i looked around on the threads but didnt see anthing explaining how to adjust the timing properly thanks!
It's controlled by the ECU at idle, you should have ~10 degrees or so. If it's off by a lot, your belt is probably a tooth off since the rotor is attached to the cam.
Comment