where is the oil level sensor plug on a 89 e30 325i

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • R1ckM
    Wrencher
    • Jan 2013
    • 217

    #1

    where is the oil level sensor plug on a 89 e30 325i

    Oil level light pop'd on, last time I had it looked over for it the shop said the sensor wire/plug just came lose and they plugged it back in.

    Going off that info, I think it may have came lose again but i can't find it.
    I assume its on the back side of the oil pan?

    If anyone can explain a bit more so I can connect it again I would appreciate it.
    Last edited by R1ckM; 05-21-2014, 03:47 PM.
  • jlevie
    R3V OG
    • Nov 2006
    • 13530

    #2
    The sensor and plug is on the left side of the oil pan, a bit forward of the center of the engine.
    The car makes it possible, but the driver makes it happen.
    Jim Levie, Huntsville, AL

    Comment

    • vpilarrt
      R3VLimited
      • Jun 2006
      • 2096

      #3


      Its the wire hanging at the bottom of the pic.

      Comment

      • TobyB
        R3V Elite
        • Oct 2011
        • 5163

        #4
        The somewhat confusing part is that when you see it, you're looking
        straight down at the top of it. It's in the bump- out in the pan.

        t
        now, sometimes I just mess with people. It's more entertaining that way. george graves

        Comment

        • Madhatter
          E30 Modder
          • Oct 2004
          • 966

          #5
          where it came loose is likely to be the connector to the loom though. Up near the front next to the timing cover on the drivers side. Should see it near the thermostat housing area.
          Just a little project im working on
          - http://www.lse30.com -

          Comment

          • R1ckM
            Wrencher
            • Jan 2013
            • 217

            #6
            Got it, thanks. Makes more sense, I was just not familiar with how the sensor was placed in the oil pan then where the connector went.
            It looks like it wire got spliced to a connector then came loose.

            Comment

            • Madhatter
              E30 Modder
              • Oct 2004
              • 966

              #7
              they crap out all the time. plastic goes really hard and the connector just pretty much breaks up into pieces.
              Just a little project im working on
              - http://www.lse30.com -

              Comment

              Working...