It always happens, you think you'll remember where everything goes and then something causes you to doubt yourself, so here I am with a couple questions:
1) Where the harness goes into the firewall to the ECU....is there an easy way to get the plug through the firewall to make the seal? I know in the glovebox area, there are, what I'm guessing, finger pulls to yank the plug through....they just seem really flimsy and I don't want to mess it up...WD40 and pull???
2) Again, where the harness goes into the firewall...I don't have a batter there, but I have the + terminal. I have accounted for all of the connections off the wiring harness except one. I'm not sure if it is a ground or connects to the terminal with the other wires. I'm almost positive I connect it to the terminal, but obviously, if I'm wrong this would be bad!
3) What is the correct routing of the oil pressure cable/plug? I think the one I pulled was around the water pump, but it didn't seem correct. Everything else went fine
4) The set of 3 x Relays.....I know the white is the main relay, can't remember what the other one is, and I have one blank spot. So, I just need to know what grouping of colored wires goes to which relay. I'm sure all the red/power wires is for the Main Relay, but then I have a grouping of green wires and another combination of colored wires. I believe the one with green wires is the one that I had blank
1) Where the harness goes into the firewall to the ECU....is there an easy way to get the plug through the firewall to make the seal? I know in the glovebox area, there are, what I'm guessing, finger pulls to yank the plug through....they just seem really flimsy and I don't want to mess it up...WD40 and pull???
2) Again, where the harness goes into the firewall...I don't have a batter there, but I have the + terminal. I have accounted for all of the connections off the wiring harness except one. I'm not sure if it is a ground or connects to the terminal with the other wires. I'm almost positive I connect it to the terminal, but obviously, if I'm wrong this would be bad!
3) What is the correct routing of the oil pressure cable/plug? I think the one I pulled was around the water pump, but it didn't seem correct. Everything else went fine
4) The set of 3 x Relays.....I know the white is the main relay, can't remember what the other one is, and I have one blank spot. So, I just need to know what grouping of colored wires goes to which relay. I'm sure all the red/power wires is for the Main Relay, but then I have a grouping of green wires and another combination of colored wires. I believe the one with green wires is the one that I had blank
Comment