I finally got engine started. So now I have new problem. Car starts and revs up to about 3000 RPM maybe 5 -10 seconds later drops. Ands starts going up and down between 1000 - 2000 rpm. It appears runs OK above 3000 rpm.
-
-
I think I got this figured out, IDLE control unit is Dead. Car runs exactly the same way with the unit removed. Plus resistance on the unit between pins 1 and 5 over 20Mohms Something is really messed up there -
what happened with this mate, I have a high idle issue on my m20 as well. Where's the idle control unit on your car? next to the ecu? cheersComment
-
Idle Control Unit is behind the glove compartment next to ECU. It looks like thisOriginally posted by R31 Mark View Post
Comment
-
Update on the problem: after replacing idle control unit. Things got better, now rpm does not go above 1200, but still bouncing between 700 and 1200. I have adjusted TPS to the correct specifications and car now run good when it is cold.
So now I am thinking the issue may have to do with the temp sensors that feed ECU, also may be fuel pressure but that maybe long shoot ( Will test it just in case). This is end up to be very tricky problemComment
-
very good write up hopping to find the answer there
Comment
-
At the end it was AFM part number for the installed was for the older 325ES 280 202 066. Correct part number should ending at 091Comment
-
good on you man, good work fixing your issue. so you have a motronic car yes? L jetronic here haha :PComment
Comment