Are there any tricks for getting these on any easier? I put a bit of oil on the rubber and I'm using a 7/16 deep socket as it seems to fit a bit better then the 11mm that the bentley suggests.
-
-
Tap them on with a soft faced hammer. Should just pop on. Make sure to use the little plastic caps over the end of the valve when re-installing the valves. -
Make sure you use the installation sleeves or the seals are going to get cut by the valve grooves.
Comment
-
Thanks for the replys, I'm down to my last 5, and don't have any extras. I can't imagine anyone installing a full set without mauling up a few. Just one went "pop" and went right on. I need to PM Mr325 and ask what the secret is. Next time I won't be a cheap ass and just send it out for a rebuild.Comment
-
You should be able to oil them and push them in by hand. 8)Comment
-
OMG! Tight as a cats assComment
Comment