I have an iX block, with an eta 81mm crank. I am planning on going turbo.
Was curious, just put in my order with VAC for rods and pistons, and they recommended going with a 135mm rod over 130.
It was my understanding that I needed a 130mm rod to fit in the block correctly? Or since they are custom CP pistons, they will change them to fit with the 135mm rods properly? let me know if I am understanding that correctly.
Thanks
Was curious, just put in my order with VAC for rods and pistons, and they recommended going with a 135mm rod over 130.
It was my understanding that I needed a 130mm rod to fit in the block correctly? Or since they are custom CP pistons, they will change them to fit with the 135mm rods properly? let me know if I am understanding that correctly.
Thanks
Comment