Announcement

Collapse
No announcement yet.

wierd bumpiness

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    wierd bumpiness

    Well after one and a half hours of searching various forums, I could'nt find shit on my problem.

    Well when I let off the throttle in 2nd or 3rd gear the car gets bouncy after it drops under 3000rpm. Feels like a stalling car. I dont even know where to start looking as none of my e30's have ever done this. Im grateful for any help you guys can give me. Thanks for reading.


    Allright guys im starting to think its a clutch issue as it goes away when i press the clutch.
    Last edited by bmw325csi; 07-08-2008, 03:22 PM.
    harry/harout

    #2
    It doen't mean it is the clutch it means it is in your drive line. So check your drive shaft guiebo, center support, and diff fluid level. worth a look if you dont know their condition.

    If it was the clutch it wouldn't grab when accelerating not decelerating.

    1986 325es (69k) Garage Queen Buy It Now 10k;1986 325es (track rat) 2.7i How-To & 1.1/1.3Motronic UpGrade
    1991 318is (daily driver) 1991 318is M42 Maintenance How-To;1989 325i (parts car)

    Comment


      #3
      Thanks for the input. I recently changed my csb and my guibo. But I think i should inspect them nonetheless. Is there any way i could of installed the flexdisc wrong?
      harry/harout

      Comment


        #4
        gearlash in your tranny or diff.
        you'll have to get under the car and disconnect the drive shaft at one place and test the tranny output and diff input.

        Comment


          #5
          ^ now when you say test, do you mean rotate and make sure it spins freely or........?
          harry/harout

          Comment


            #6
            wonder if you put the drive shaft together wrong. They are balanced together at the factory. and +1 on other suggestions so far.

            Comment


              #7
              ^ im fairly sure I put it on right. I marked it before i took the halves apart.
              harry/harout

              Comment


                #8
                I vote for driveshaft. sounds like a bad u joint to me. But I could be wrong of course...

                Comment


                  #9
                  broken drivers side engine mount

                  Comment


                    #10
                    ^ yeah? but would that go away every time i engage the clutch?
                    harry/harout

                    Comment


                      #11
                      throw out bearing.
                      Need a performance chip for you BMW? Shoot me a PM and I'll get you taken care of!!
                      Taylor- Follow me on Instagram @e30_fiend


                      Comment


                        #12
                        if you are at 10-25 mph and in 1st-3rd gear and not on throttle and the car goes into a lurching motion, then yes, likely an engine mount.

                        the engine and cars momentum are fighting eachother. if you get on the clutch, the cars momentum is not there to torque the engine off the mount. While applying throttle, the engine is leaning on the broken mount and pulling on the good one, while carrying the car's mass.

                        just a suggestion.

                        Comment


                          #13
                          ^thanks! going under car........Now.
                          harry/harout

                          Comment

                          Working...
                          X