Hey there. I've got a '89 325i, and I cracked the oil pan a couple of days ago (because of course I did), and I tried to swap it myself. I actually was successful in doing so minus the part where I snapped a bolt in the engine block while screwing the new pan in but that's neither here nor there. The issue I'm currently dealing with is that in order to get the pan out and in, I lifted the engine off the subframe, but far enough out that I can't figure out how in the world to realign it and lower it back onto the subframe to secure it. Right now the engine is being held up by an engine support bar. Has anyone dealt with this before and have any advice?
Thanks!
Thanks!
Comment