Like the title states, how did you all seal your dipstick tube housings? There's no o-ring unlike the 24V engines which the dipstick tube housing goes into the oil pan.
I'm in process of putting my M20B25 back together and, after cleaning the dipstick tube housing hole in my block, the new dipstick tube housing is very slightly loose (i.e., not a press fit into the block anymore).
Should I RTV the dipstick tube housing base and just drop it in the block hole?
I'm in process of putting my M20B25 back together and, after cleaning the dipstick tube housing hole in my block, the new dipstick tube housing is very slightly loose (i.e., not a press fit into the block anymore).
Should I RTV the dipstick tube housing base and just drop it in the block hole?
Comment