Announcement

Collapse
No announcement yet.

Getrag 260/6 Question

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Getrag 260/6 Question

    I'm swapping an M30B35 into my 84 E30. I picked up a Getrag 260/6 transmission to go with the M30.

    I was just trying to mate the two up but I couldn't quite seem to get the tranny flush with the engine. Despite my efforts there remained about a 1/2" gap.

    I'm wondering if the input shaft on the transmission is somehow hanging out too far on the transmission. I've never seen a Getrag 260/6 outside of a car but from pictures I've seen online, my input shaft seems to protruding a bit further than those. See the pictures below.

    [IMG][/IMG]


    #2
    1)Did you put it in gear and turn the output shaft to get the splines to line up during the stab.
    2)Did you confirm the pilot bearing is the correct fit for that input shaft?
    3)Clutch alignment tool to ensure clutch plate is centered?

    Comment

    Working...
    X