Hi everyone,
I'm trying to diagnose an intermittent stumble when the engine is under load, ex. at 50% or more throttle at low RPMs or when pulling away from a stop in first gear. Already replaced all of the vacuum hoses and intake boot so I'm fairly sure it's not a vacuum leak.
I had read that some other people with a similar issue solved it by replacing the spark plug wires. But before I spend $150 on new wires I want to make sure mine are bad. Does anyone know what the resistance spec should be on these wires? All four of mine measure about 5.5-5.8 k-Ohms. They look to be in OK shape, but I noticed the boots say "made in W. Germany" on them, so it's possible they are the factory wires.
Thanks!
I'm trying to diagnose an intermittent stumble when the engine is under load, ex. at 50% or more throttle at low RPMs or when pulling away from a stop in first gear. Already replaced all of the vacuum hoses and intake boot so I'm fairly sure it's not a vacuum leak.
I had read that some other people with a similar issue solved it by replacing the spark plug wires. But before I spend $150 on new wires I want to make sure mine are bad. Does anyone know what the resistance spec should be on these wires? All four of mine measure about 5.5-5.8 k-Ohms. They look to be in OK shape, but I noticed the boots say "made in W. Germany" on them, so it's possible they are the factory wires.
Thanks!
Comment