1991 318is diff fluid

[immajackuup]

Is this the correct diff fluid to use?
Mobil/1 qt. 75W-90 synthetic gear oil

http://www.autozone.com/autozone/acc...fier=1437_0_0_

Also when putting back rear diff cover do I use alittle bit of rvt on paper gasket or just paper gasket??

[KenC]

Why are you taking the diff cover off? RTV will work if you let it cure.

It's a little more than a quart I think. Make sure it has an LSD additive if your diff is an LSD.

[Holland]

It will take a little more than a qt.

[///digitalme]

^ what he said. I used redline also while you're down there change your tranny fluid. Redline mtl is a great oil to use!!!

[immajackuup]

Why are you taking the diff cover off? RTV will work if you let it cure.

It's a little more than a quart I think. Make sure it has an LSD additive if your diff is an LSD.

pulling diff cover off to replace bushing with akg poly. Guess i put some honda bond on the paper gasket to make sure it seal.

[trigtm]

pulling diff cover off to replace bushing with akg poly. Guess i put some honda bond on the paper gasket to make sure it seal.

I've replaced the diff mount bushing with the cover still on so I wouldn't take the cover off unless it was leaking and neede a reseal.

RTV as stated works fine. Honda bond is the same material more or less.

[jrobie79]

I thought the small case LSD's were a little under a quart?

[immajackuup]

I've replaced the diff mount bushing with the cover still on so I wouldn't take the cover off unless it was leaking and neede a reseal.

RTV as stated works fine. Honda bond is the same material more or less.

How you manage to remove diff bushing without pulling rear cover off?? Also I like honda bond over rtv because is easy to clean up.

[harv]

HondaBond is the shit! Been using it for years. You can also use YamaBond but I'm partial to Hondas.

John

[Nick_S]

I thought the small case LSD's were a little under a quart?

Mine was. Just under a quart it started coming out the fill plug. And OP, I used Mobile1 75w-90LS for the LSD.

[immajackuup]

I've replaced the diff mount bushing with the cover still on so I wouldn't take the cover off unless it was leaking and neede a reseal.

RTV as stated works fine. Honda bond is the same material more or less.

How you manage to remove diff bushing without pulling rear cover off?? Also I like honda bond over rtv because is easy to clean up.

[lbreevesii]

you can use a hacksaw blade to cut the outer ring of the old bushing then it will pop out easily, I did it on the workbench.

[Jaxx_]

you can use a hacksaw blade to cut the outer ring of the old bushing then it will pop out easily, I did it on the workbench.

torch if you really have to, but I wouldn't really want to do that with it still near the car.


I'm using LS 75W-140 from mobil 1. it's a bit noisy when going around turns on the street or when cold, but the lockup is solid and because of the autox I opted for a heavier weight. I'm satisfied with it, but I wouldn't recommend it for a daily or primarily street car.

[immajackuup]

torch if you really have to, but I wouldn't really want to do that with it still near the car.


I'm using LS 75W-140 from mobil 1. it's a bit noisy when going around turns on the street or when cold, but the lockup is solid and because of the autox I opted for a heavier weight. I'm satisfied with it, but I wouldn't recommend it for a daily or primarily street car.

then what you recommend for daily?? im still gonna pull rear casing off to put on new seal and press bushing out.

[Jaxx_]

then what you recommend it for a daily?? im still gonna pull rear casing off to put on new seal and press bushing out.

a lighter fluid... the 75W-90 should be fine, but if the diff chatters and is annoying you might want to put in a little friction modifier.