Timing chain rattle?

[roguetoaster]

honestly no there wasn't it looked like a 160k mile engine so what ever the issue is must be from down under.

This is where an inspection scope comes in very handy. I've been happy with the fairly cheap Aardvark scope I got a few years ago.

I look forward to your tear down/inspection results.

Not really, it's the most fragile part of the system, but it should be under $120. Best real solution is to go early E36 M42 timing case, which is a fair amount of difficulty and cost.

[ThatOneEuroE30]

I'd run those. Any other clues from removing the VC?

Missed your PM.

PN: 11311727569
Reference: http://bmwfans.info/parts-catalog/E3...in/#1727569_11

honestly no there wasn't it looked like a 160k mile engine so what ever the issue is must be from down under.


man you werent kidding 160 bucks for the sprocket... is there any way to go with out haha

[roguetoaster]

I'd run those. Any other clues from removing the VC?

Missed your PM.

PN: 11311727569
Reference: http://bmwfans.info/parts-catalog/E3...in/#1727569_11

[ThatOneEuroE30]

Id have to say these cam gears are in good shape?

[ThatOneEuroE30]

If the cam gears are lunched PM me, I probably have a couple of decent used sets for cheap. Most important in an E30 M42 timing chain overhaul is the deflector sprocket IMO, it's also expensive.

You will no doubt get a pm from me.

[roguetoaster]

I will do a tear down over the weekend. In the mean time i went ahead and ordered a timing kit and some other misc stuff from fcp euro. I'm really hoping my cam gears arent shot that will be the death of me financially after ordering all this shit.

If the cam gears are lunched PM me, I probably have a couple of decent used sets for cheap. Most important in an E30 M42 timing chain overhaul is the deflector sprocket IMO, it's also expensive.

[ThatOneEuroE30]

Whoa, why are you in M42 land?



Yeah, sounds like a guide has gone MIA and the chain is rubbing aluminum. Alternate theory, a bolt has backed out of the DS main guide and is rubbing the chain case.



You need to inspect this ASAP. Remove the upper timing cover at minimum. I suspect that you'll see pointy teeth on your cam gears as well.

I will do a tear down over the weekend. In the mean time i went ahead and ordered a timing kit and some other misc stuff from fcp euro. I'm really hoping my cam gears arent shot that will be the death of me financially after ordering all this shit.

[roguetoaster]

Guides?

Whoa, why are you in M42 land?

Yeah, sounds like a guide has gone MIA and the chain is rubbing aluminum. Alternate theory, a bolt has backed out of the DS main guide and is rubbing the chain case.

You need to inspect this ASAP. Remove the upper timing cover at minimum. I suspect that you'll see pointy teeth on your cam gears as well.

[ThatOneEuroE30]

Guides?

Kind of beginning to think so. It only happens at 1900rpm though then goes away.

[Kershaw]

Guides?

[ThatOneEuroE30]

Replaced the tensioner on my car and it still has a rattle in the same rev range what could it be?

https://youtu.be/6PkI48FQHDg