I could use a few idea's here. my driveshaft alignment bushing needs to be replaced. It is the piece that is pressed into the hole at the front of the front section of the propeller shaft. I have no clue how to go about replacing it. any ideas would be good. this is on an 85 325e manual. Also, on a side note, I need to check the condition of the u joint. it moves freely, with no resistance/noise, but I could not drive it to test it, as when I bought the car it had 1 bolt holding the trans up, crooked. so I didn't push it. any way to check this while it is down?
Announcement
Collapse
No announcement yet.
driveshaft alignment bushing
Collapse
X
-
Originally posted by turnofftheradioshit, It doesn't matter anyways now, upon close inspection, my driveshaft ears are bent. I hate the previous owner :evil: going to get a driveshaft. thanks anyways.
I see whatcha mean now. Not sure if mine has that either. Meh.- Sean Hayes
Comment
Comment