Lighted flywheel typical price?

[CR325IS]

What is the average price shops charge to lighten a stock "i" flywheel down to 14 lbs?

[e30 gangsta]

i paid $80 resurfaced, balanced and shaved.

[Stoner Sam23]

I paid 100$ got down to 13.5 lbs

[CR325IS]

safe to say around 100$?

[pantelones]

I was shopping around to get my single mass eta resurfaced, lightened, and balanced; and I ended up paying $110. One shop wouldn't do it, and another wanted $450 to do it. You have to be careful and find a good shop, or you could pay a hefty price. Pun intended?

[CR325IS]

I am picking mine up tomorrow 159.75 and they got it down to 13.8lbs. I couldnt find anywhere in my area any better than that.

[drumad]

mine cost 160ish

[MR 325]

$100 is about the going rate but even at $160 that's a much better price than buying an aftermarket one!

[e30leigh]

how safe is the lightening? it doesnt weaken the flywheel too much?

a high clamp loading pressure plate isnt going to over stress it? and it will stand up to horse power and torque sweet as?

[drumad]

$100 is about the going rate but even at $160 that's a much better price than buying an aftermarket one!

I knew it was sorta high but the machine shop quoted me 300 at first lol.

I ran with it bc the shop is very reputable and badass.

Plus I got the flywheel for 20 dollars shipped.

[slammin.e28]

how safe is the lightening? it doesnt weaken the flywheel too much?

a high clamp loading pressure plate isnt going to over stress it? and it will stand up to horse power and torque sweet as?

It's fine. For reference:

M30s. Stock have a 26lb FW.

S35s stock have the same FW, but it weighs 15lbs.

S35 is much > M30.

You'll have no problems.

[nando]

I paid $35. :D

[gearheadE30]

Wow, most of you guys paid a lot...Mine ran $60 resurfaced, lightened, and balanced.

[e30leigh]

wow. in that case ill have mine machined down. heaps cheeper then going a/m just just ditch 3 lbs

[justin_l_]

I did mine myself, got it down to 12 lbs.