Flywheels 325e and 325i Single Mass

[tytypetersen]

Here's a couple pics of an 325e fat single mass and a 325i single mass. The e came out of a 02/86 car with a deep bell housing on the transmission.
The 325e is 38 mm thick and the 325i is only 33mm. 325e's also came dual mass.

[efficient]

So what is needed to run the I flywheel on a I motor with the e trans?

[SmokeE30]

You need a longer throw out bearing, search around for the part number but I believe the one I used was off a 533i

[tytypetersen]

Part number for the throw-out bearing is,......21511204525. It for a 323i. Sometimes called a euro throw-out. They're about $75.

You only need this if you have the longer e Getrag 260 bell housing. I put some pics on R3V showing the difference between an e and I Getrag 260 a few weeks ago. Take a look.