86 325E using a 91 325 CI Driveshaft

[Smrtpunk]

Is it possible? If so what is involved. I think my U joint on the E is bad and I would like to swap the whole unit if possible.

Thanks,
Ian

[MR 325]

If both are 5 speed cars it will work.

You'll need to change your center support bearing though since early and late model are different.

[Smrtpunk]

If both are 5 speed cars it will work.

You'll need to change your center support bearing though since early and late model are different.

Excellent! I read somewhere that the output shaft on the I Trans is different then the E will this affect the setup?

When I pull the driveshaft from the I car should I order a new CSB for an E car? I'm guessing re-using the old CSB would be a bad idea.

Thanks for sharing your wisdom!

[MR 325]

The 87 325e had the larger flange during some months of production but the majority of 325e cars use the small flange just like the 325i.

I'd recommend buying a new CSB and guibo if they're in bad shape. Go with Febi brand and not a cheapo.