If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I just put an m20 back into my black car with a 260 tranny. I cant for the life of me get the drive shaft figured out, its to short. what could i checkl.
It's two pieces and it can expand and contract. Right near the CSB there is a threaded sleeve. Loosen that up, extend the shaft, and tighten it back down.
Comment