Just got done buttoning everything up after a 5spd swap in my 88 SETA.
Used a Dual Mass Flywheel and this clutch kit:
http://www.ebay.com/itm/151062688299...84.m1497.l2649
Started the car and clutch won' fully engage.
The car will barely move when in gear and the clutch is smoking a little.
It's like the clutch is slightly disengaged just enough to not make good contact.
What would cause this to happen?!?!
Could I have installed the clutch disc backwards our maybe used the wrong throw out bearing?
Please help
Used a Dual Mass Flywheel and this clutch kit:
http://www.ebay.com/itm/151062688299...84.m1497.l2649
Started the car and clutch won' fully engage.
The car will barely move when in gear and the clutch is smoking a little.
It's like the clutch is slightly disengaged just enough to not make good contact.
What would cause this to happen?!?!
Could I have installed the clutch disc backwards our maybe used the wrong throw out bearing?
Please help
Comment