So I have this m52 and zf trans, s52 clutch installed, put the clutch in with the side marked "gearbox" facing the trans. I get the input shaft at least partially into the clutch splines but it will not go on any further. I have about a 1 1/2" gap. I've tried tightening up what bolts I could get started to pull it together, it was resistant to the point I didn't want to push the issue any further.
Think I just need to clean up and grease the input shaft? I mounted the clutch with the longer splined portion facing the engine.
Think I just need to clean up and grease the input shaft? I mounted the clutch with the longer splined portion facing the engine.
Comment