Driveshaft spacers???

[Garageaholic]

In my M30 swap, I find out that the driveshaft is about a half inch short... on the input end (with the guibo)..

What would you guys think about putting spacers in between the flange of the shaft and the flex disk on the tranny? do you think there'll be major vibration? bc it is still centered on the mini shaft on the transmission.....

What do you think?

[AdamF 88iS]

The driveshaft can be adjusted for lenght. Unless you're maxed out on that then there is no need for any mickey mouse stuff.

[Garageaholic]

not that it was maxed out, but the slots on the center bearing werent' any longer.... maybe it was maxed out... i dunno.

Does anybody know how much it costs to get the front half lengthened by 1/2"??

not only that but will there be any front half driveshafts out there that are a little longer and will still fit the E30?