Driveshaft spacers???

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Garageaholic
    Freestyle Fabricator
    • Dec 2005
    • 5204

    #1

    Driveshaft spacers???

    In my M30 swap, I find out that the driveshaft is about a half inch short... on the input end (with the guibo)..

    What would you guys think about putting spacers in between the flange of the shaft and the flex disk on the tranny? do you think there'll be major vibration? bc it is still centered on the mini shaft on the transmission.....

    What do you think?
    Recent Rebranding!!
    Visit Garageaholic for all of your E30 Swap Needs!
    E30 SM62/S62
    E30 M60 V8
    E30 M30 Big 6!




    Check out this E36 N54 Swap Build
    Instagram.com/garageaholic
    Youtube.com/garageaholic
  • AdamF 88iS
    R3VLimited
    • Oct 2003
    • 2051

    #2
    The driveshaft can be adjusted for lenght. Unless you're maxed out on that then there is no need for any mickey mouse stuff.
    Adam Fogg- '88 M3

    Common sense- It's the new 'gifted'

    Comment

    • Garageaholic
      Freestyle Fabricator
      • Dec 2005
      • 5204

      #3
      not that it was maxed out, but the slots on the center bearing werent' any longer.... maybe it was maxed out... i dunno.

      Does anybody know how much it costs to get the front half lengthened by 1/2"??

      not only that but will there be any front half driveshafts out there that are a little longer and will still fit the E30?
      Recent Rebranding!!
      Visit Garageaholic for all of your E30 Swap Needs!
      E30 SM62/S62
      E30 M60 V8
      E30 M30 Big 6!




      Check out this E36 N54 Swap Build
      Instagram.com/garageaholic
      Youtube.com/garageaholic

      Comment

      Working...