I have an early 08/84 325E I am planning on doing a 5 speed swap on. I have a Early 10/83 528E 5 speed I will be scrapping. It seems several parts are swappable. I am reading that I can just add the manual pedals to my existing auto pedal box? Except I guess the early pedal box does not have provisions for the clutch cylinder mount? Also both cars have transmissions that use Non-Guibo drive shafts. I realize I need a 3 series drive shaft, but have not seen any Non Guibo set ups besides mine.
Announcement
Collapse
No announcement yet.
Drive shaft question
Collapse
X
-
Another question you may have the answer to. I also have a 84 745I, It developed a major leak on the cannon plug on the lower side of the transmission where the wire for the electronic shift solenoids goes. It has a 4HP22 transmission with the dial selector on the console. I was able to find a used section of the wiring. But it was cut just before it enters the floor. Any chance you have a part number for this? I know 5 series had this trans not sure if 3's did.sigpic
Steve Corbett
1983 528E Scrapped
1983 528E Sold
1984 745I
1984 325E - Sold
1989 325I Bronzit-Sold
1989 325I Zinno
1988 635CSI
Comment
Comment