I'm trying to tighten up my shifter and this piece is causing a lot of slop. I have a new one, but I can't get a wrench into where the bolt is, and the guide I'm using for the shifter rebuild uses a different piece for this entirely, I think it changed on late models. Do I have to remove the driveshaft? And if I do is there a way to convert to an easier to remove version of this so I don't have to do this again?
Here is the photo: http://puu.sh/hCXRE/a98e6531aa.jpg
Here is the photo: http://puu.sh/hCXRE/a98e6531aa.jpg
Comment