Announcement

Collapse
No announcement yet.

i may have messed up jacking up transmission

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    i may have messed up jacking up transmission

    I was in process of removing driveshaft so i can drop tank. I jacked up the transmission (manual) about an inch and remove the brace. I changed the mounts while i had it out. The tranmission apparently shifted on the jack and now it is touching the top of tunnel and shifted towards passenger about 5 degrees. How do i fix this?


    https://photos.app.goo.gl/cAN9tous4eWF2GXt7

    I cannot attach a pic so hopefully this works.
    Last edited by doctorx; 05-16-2019, 09:20 PM.

    #2
    Check your motor mounts to see if they've been damaged when jacking up the trans. You should loosen them up too, shouldn't have to take them out though.
    sigpic

    Comment


      #3
      How on earth have you done that? is it still on the jack in the photo?

      I would take the gearbox cross member off, drop the transmission down. Attach x-member to transmission, then jack it all back up by the transmission. *should* all fall into place.

      Comment


        #4
        :stupidsign:

        derp... the crossmember was installed backwards... teach me to work on something after 9pm.

        Comment

        Working...
        X