Wtb: m60 low pressure power steering washer-ring

[Garageaholic]

I seemed to have lost one of the low pressure banjo bolts that connects the low pressure lines directly to the m60 power steering pump

If I could order the part, I obviously would, but it looks like realoem.com doesn't show it as a listed part.

This part does not fit the m20 power steering banjo bolt or I would use it. It's too big

http://realoem.com/bmw/showparts.do?...80&hg=32&fg=20

It's number 20, "A20" washer.

[bmwmech1]

Frank, I have a couple of them... left over from the parts accumulation for my project. Give me your address and I'll send you a banjo bolt and both washers. It must be listed on another diagram on RealOEM... usually, if it shows a picture of the part, but doesn't give a part number for it, it's listed on another diagram...

Garey

[bmwmech1]

Frank, I sent the banjo bolt and washers out this morning. Tried to PM you, but your box is full...:(

Garey

[Garageaholic]

Wow. Ok ill address that immediately. Thanks again! !

[bmwmech1]

Np...

[Jonsku]

Just in case, the part numbers can be found here..





They are normal M14 / M16 / M18 banjo bolts... is there a reason for using old washers .. ?

[Garageaholic]

What's the P/N for washer #20? That's what I needed but the P/N is not listed anywhere, which is why I asked for a good used one.

[JGood]

It's just a normal 18mm crush washer. You don't really need the BMW part.

If you want the BMW part, you can do a cross-ref search on the bolt part number, and check the diagram for another vehicle, and see if the washer is listed.

Looks like the washer is 32411093598.

[Garageaholic]

Yeah you're right. I never considered that tool in realoem.