After over a week of running through the ETM's and comparing various other swap guides, I've gotten this far but need help in completion.
My car is a 05/85 325e, which had the square c101. I stroker-swapped the engine previously and had to convert the square to a round C101 from an 87 325i.
Wire colors are noted from body side on the e30, going to pins in the round c101. X20 harness is from a 94 530i/5 and wire colors are noted as engine side.
Do all the wires combo's look correct to you guys?
The one's I question are lines 31, 32, 35 and 36 as noted in the excel sheet below.
I'm not sure what line 31 connects to in the x20 harness, and I think line 32 is the correct connection?
Are the functions for 35 and 36 being connected from x20 to c104? If so, what wire/pin are they connecting to on the x20?
My car is a 05/85 325e, which had the square c101. I stroker-swapped the engine previously and had to convert the square to a round C101 from an 87 325i.
Wire colors are noted from body side on the e30, going to pins in the round c101. X20 harness is from a 94 530i/5 and wire colors are noted as engine side.
Do all the wires combo's look correct to you guys?
The one's I question are lines 31, 32, 35 and 36 as noted in the excel sheet below.
I'm not sure what line 31 connects to in the x20 harness, and I think line 32 is the correct connection?
Are the functions for 35 and 36 being connected from x20 to c104? If so, what wire/pin are they connecting to on the x20?
-
Comment