If I remove my support bearing (whole mount) do I need to have the new one pressed in? My haynes (i dont have a bentley unfortunately) says I need the old one pulled out at a machine shop, yet they have a picture using a puller to remove the mount. I need to get this and everything else under the car taken care of before winter. Thanks
Announcement
Collapse
No announcement yet.
? about center driveshaft support
Collapse
X
-
Thats what I had in mind. Should make for an interesting weekend. I have to remove the exhaust, driveshaft, transmission, clutch, and oil pan. My rear main seal is leaking and my oil pan gasket and oil change are long over due. pan is leaking. I cant wait.
off topic on my own thread, but does anyone know what type or size fitting I can use for my oil pressure sender? Or is it easier to drill and tap into the pan? I need to monitor my old motor to make sure my pump isnt going bad.Old and improved:
Comment
Comment