Anyone heard of this stuff?

[Skafrog]

I'm Drunk

:D

[trent]

I'm Drunk

:D

wtf i didn't say that

digkhead

[Streetspec_iS]

snake oils rule

so does goanna oil. id like an old VW diesel so i could run on vegetable oil.

[MR 325]

Do does everyone think I am a moron here or what? Seriously

[Streetspec_iS]

Do does everyone think I am a moron here or what? Seriously

[grapedrink]

Its always good to put shit in your motor that is made to clog up parts :roll:

[golde30]

$40/tube and 3 tubes to complete the process? and u cant drive in excess of 2700RPM during the first 400miles? well, this process takes some serious commitment. i would botch it as soon as i pull outa my driveway :roll: .

[Jordan]

u cant drive in excess of 2700RPM during the first 400miles?

My car can't go that slow. I would die.

[cahomey]

First off, that was a different product and was 4 years ago.

I am only going to try this because a friend has tried it himself and has SEEN RESULTS.

Obviously all these guys claim results but this shit really does work.

What does it matter if it was 4 years ago? All that shit has been in our planet for days.
Seen as in accually looked inside the engine?

[MR 325]

Whatever guys, I could really care less if it blew the damn motor, it's trash anyway... But it won't.

[GaryE30]

I say if you've actually seen what it can do. Then no harm, go for it.

[e30evolution]

if it works let me know..... i got a car with 22% leakdown

[Madhatter]

You arent the same guy that posted on dtm are you? http://www.dtmpower.net/forum/showthread.php?t=140986

To quote what i said last time,

Until someone tests it and actually shows the surfaces changing, i wont believe shit. I still want to know how they increase compression ratio, you want the rings to bite into the bore, you want things fairly rough. The bores arent perfectly round, neither are the rings, they are designed to scrape the oil from the bores as they pass. Anything which lowers the friction between these surfaces by claiming to smooth out the metal surfaces is just describing the problem of bore glazing. Something you dont want.

Hardened rings, hardened bores, less friction = increased blow by. I wouldnt touch it until independant testing is done (and published) for that very simple reason.

[MR 325]

No I'm not the same guy that posted it on DTM, my username is MR 325.