what do ya'll use to remove the rockershafts for replacement? like what do u use to drive them out, without damaging them?
-
-
I use a socket with the same outside diameter as the shafts and some long extensions, then hammer on the extension(i've got one mangled one to hammer on)85 325e 2.7 ITB'd stroker
-
The rocker shafts should not be difficult to slide out, although mine were due to a warp in the head. I got mine out with a brass drift (always good to use a softer material than what you are hammering on), intending to replace the end caps. I then had the head annealed and pulled straight again.Comment
-
Who the hell around here did that for you? Dan Hall?Originally posted by cthulu703Tenured Automotive Service Professional - Avid BMW Enthusiast
Vapor Honing & E30 ABS Pump Refurbishment Service
https://mtechniqueabs.com/Comment
-
Get out of my head!Comment
-
lol. I will take that as a yes.Tenured Automotive Service Professional - Avid BMW Enthusiast
Vapor Honing & E30 ABS Pump Refurbishment Service
https://mtechniqueabs.com/Comment
-
I've always used a wooden dowel and a rubber mallet. Cleaning the built up gunk on the shafts helps out a lot.Don't forget the good things Hitler did.Comment
Comment