Announcement

Collapse
No announcement yet.

Stomp code 1211

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Stomp code 1211

    So my CEL is on all the time, and doing the stomp test gives me a 1211. I tried disconnecting the battery for a minute letting it run for 30 seconds, then letting it sit for 30 seconds, and it still gives me the same code.

    The only drivability problem I have is a pretty poor idle. It's around 900 RPM and very rough, the whole car shakes. Other than that it runs perfect.

    It's a 1987 325i with a 173 DME, Mark d chip. The engine is a 2.7 stroker.

    Thoughts?

    #2
    1211 = DME Control Unit..

    http://e30world.com/fuel/BMW-E30-DME...ic-fault-codes

    for the poor idle did you check your ICV?

    Comment


      #3
      Since a power reset resulted in the 1211 reappearing, replace the DME.
      The car makes it possible, but the driver makes it happen.
      Jim Levie, Huntsville, AL

      Comment

      Working...
      X