Revisiting: No windows and the Unloader Relay..

[BMWLOCO]

Troubleshot all the recommended issues except bridging the starter posts because I didn't have a strong-enough wire. Replaced the K5/K7 relays and still no power windows. The AC blows OK.

Since the dash-board is off, I'm able to trace all the wires locations, but I'm thinking that something might be array in the harness area.

What else should I do to get the windows to power?

Is there anything in this picture that looks like it's missing? I don't see any additional cables needing plugged, except I plugged the little black-two-prong cable that goes on the green fastener in back of the cluster. (There are 3 places it plugs in... WHICH ONE).

[StereoInstaller1]

Grab your testlight and see if you have power at the window switch first, then test the circuit breaker.

If you do not own a test, hie thyself immediately to your local auto parts store or Mart of Wall and purchase one. Do NOT use a multimeter to test power, use a test light.

Did you download the electrical troubleshooting manual (ETM) yet?

Luke

[BMWLOCO]

Grab your testlight and see if you have power at the window switch first, then test the circuit breaker.

If you do not own a test, hie thyself immediately to your local auto parts store or Mart of Wall and purchase one. Do NOT use a multimeter to test power, use a test light.

Did you download the electrical troubleshooting manual (ETM) yet?

Luke

I have a 12v test light.. What circuit breaker? I guess I should d-load the ETM.. NAAAAAAAAOOOOOOOOO...

[StereoInstaller1]

the pushbutton that kills window power is also a circuit breaker.

BTW, the unloader relays are fine or you would have no HVAC fan