first post, brand new member, not new to bmw, thanks.
ok my first e30 its an 1987 325e not even fully paid for yet. this is a project and will be built taking my time & sourcing parts.
so that said, i want to widen the car, not just with M fenders or arches, widen the car to 73" ( the width of the e31 ) a stock coup is 65.4", that's 7.6" over stock & 3.8" on either side of the trans tunnel, ( i have read not to cut into the tunnel, i will research this further ) that is welded in material most likely from a donar...
had a question about suspension geometry, for folks who could be helpfull in this area an i going to through off the current geometry, can camber caster adjustment help, engine is TBD.
thanks again,
ok my first e30 its an 1987 325e not even fully paid for yet. this is a project and will be built taking my time & sourcing parts.
so that said, i want to widen the car, not just with M fenders or arches, widen the car to 73" ( the width of the e31 ) a stock coup is 65.4", that's 7.6" over stock & 3.8" on either side of the trans tunnel, ( i have read not to cut into the tunnel, i will research this further ) that is welded in material most likely from a donar...
had a question about suspension geometry, for folks who could be helpfull in this area an i going to through off the current geometry, can camber caster adjustment help, engine is TBD.
thanks again,
Comment