so I put a new valve cover gasket on, tightened every bolt down, one of them a little too much and this happened...:eeek: any ideas on how i can get this fucker out??thanks..
Attached Files
-
-
take the valve cover off and use vice grips -
yes..... that's a good idea.ლ(ಠ益ಠლ)Be Afraid Of The FutureComment
-
What's with all of these retard threads today?Originally posted by nando View Post
I was a full moon last night.1974.5 Jensen Healey : 2003 330i/5Comment
-
I've never been a full moon myself. How was it?Originally posted by slammin.e28 View Post91 318is M50 swapped
05 Honda Pilot
24V swap thread
http://www.r3vlimited.com/board/showthread.php?t=302524Comment
-
-
If the vice grip method does not work for you then center punch it, drill and easy out is another way.
Comment
-
stop working outM30 is God's motor.....but Jesus drives an M60'd car -slammin.e28Comment
-
Use tq wrench next time to get a feel for how tight it should be. You can most likely get it out by doing what they said above & take off the valve cover. Then use some vice grips to get the stud out
'73 2002 m20 turbo [sold] '87 rat rod 325is [couch modded] '91 vert [daily] '88 325is [spec build v1] '84 325 [spec build v2] '99 323i vert [sold]Comment
-
have you tried being nice?
Comment
-
Next time don't crank the valve cover nut on there like the Hulk. Snug with a 1/4" ratchet is all you need.Comment
Comment