If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I was trying to diagnose my lack of brake lights and decided to undo the kick panel and check the brake switch. I found this wire just hanging there not connected to anything. Anyone have any ideas?
C1 connector for chime module. Red/Green wire - power, Brn/Grn wire - is the ground for the seat belt and key in ignition when dirver door open chime. The other connector to the chime module is C2 which is primarily from the on-board computer if so equiped.
Comment