If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How much cable did you use to run the power from the engine bay? I plan on doing the same conversion. I have to clean out trunk though first.
Most e30 have the batt in the trunk. The wire size? I think it's double ott. But the best thing is to buy a used set up. It's about $50 of copper you can get for $25 if you shop right.
Originally posted by Matt-B
hey does anyone know anyone who gets upset and makes electronics?
Most e30 have the batt in the trunk. The wire size? I think it's double ott. But the best thing is to buy a used set up. It's about $50 of copper you can get for $25 if you shop right.
Thank you sir. I live in Greece. So parts are easy to come by here. I stripped the trunk of all carpet and next step is to seal all the holes. Going to leave it bare. No carpet, Just spare tire and jack and maybe a small toolbox. Will post photos soon.
I normally strip everything but leave the mat so stuff doesn't clank and clunk around when driving, that's the only carpet I leave. and scrape out all the tar and sound insulation while in there
I normally strip everything but leave the mat so stuff doesn't clank and clunk around when driving, that's the only carpet I leave. and scrape out all the tar and sound insulation while in there
I will probably leave the mat also. I purchased the cord. I will be posting photos soon. I picked up rear end also for disk conversion. posting this photos also
Comment