trying to get a parts list for the manual swap...

[natorious]

what parts to do i need to get this swap done...

i would love to just get a parts car but i have no place to put one so thats not gonna happen...


here is what i have on the list so far

e30 tranny
driveshaft
center bearing
guibo
transmission mounts
flywheel
shifter platform
pedal assembly


what else am i missing
what hydralic components am i missing?
clutch master and slave?

are sedan and coupe drive shafts the same?

will an e36 transmission fit...

what is the best LSD to swap in while i am doing this

the car is an 89' 325i sedan with 4HP22 auto-tragic

hopefully i can get all the parts and start installing it mid-april

[Bill 84 318i]

Parts I'd get...

New:
Clutch assembly (disc, throwout bearing, pilot bearing, pressure plate, pivot pin)
Seals (engine rear main, tranny input, tranny output, selector shaft)
Guibo/center support bearing
Shift assembly bushings
Tranny mounts (and engine if they haven't been done in awhile)
Master/slave cylinders
Flywheel bolts
Pressure plate bolts

Used:
e30 (Getrag 260) transmission and rear mounting bracket
Driveshaft (yes, coupe and sedan are the same size)
Clutch hydraulic lines (solid one from MC to 2nd line, rubber/solid one from 1st line to slave)
Pedal box
Flywheel (get it resurfaced)
Shift console (maybe a new Z3 short lever to go with it)

Disclaimer: may have forgotten something, but pretty sure that's it.

I think it's easiest to get it all off one car, personally. Lots of small differences between models and years.

[m42technic]

*cough*TJ*cough*

;)

[M-technik-3]

*cough*TJ*cough*

;)

:D I'm beginning to think he can't drive a standard shift car. ;) Mine drove me nuts so it's gone, see ya automagic.

[KenC]

Contact Ryan ('super_eta'). He's got all the parts necessary for a 5-speed swap and he's looking to unload them.
His AIM s/n is Ryan325eS

[Super Eta]

Contact Ryan ('super_eta'). He's got all the parts necessary for a 5-speed swap and he's looking to unload them.
His AIM s/n is Ryan325eS

Yes i am and will let everythin go for 350+ shipping with new driveshaft.

Beware that shipping all of this wont be cheap. :?

[natorious]

sending you a PM