Announcement

Collapse
No announcement yet.

Where is the oil level sensor - Do they normally go bad?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Where is the oil level sensor - Do they normally go bad?

    My new check panel works great. Confirmed that the oil level sensor is in fact bad. I checked the oil a 10th time just to confirm :) Do these normally go bad? Annoying to have the light on :(


    Also where is the oil pressure sensor?


    1989 325i

    #2
    I know they break like crazy on e46s.
    sigpicFormer professional wrench thrower.
    Current:
    1988 325is S52
    Former:
    2008 Sparkling Graphite M3 Sedan(victim of home ownership)
    1988 M5
    1996 328is

    Comment


      #3
      e46 ftl

      I know this already ;)

      Comment


        #4
        I had that problem on my 325is. It is on the top of the pan kickout on the driverside. Disconnect it and undo the two 10 mil bolts that hold it in place. Take it out and clean it out with some brake clean/carb cleaner. Let it dry for a few hours or overnight and reinstall. Be very careful not to drop anything in there in the process.

        It usually takes a bit for the check code to reset with the oil level sender. Disconnecting the battery accelerates the process.
        :: PNW Crew ::
        '87 325 4dr, '74 2002

        Comment


          #5
          Thank you sir for the good tip!

          Comment


            #6
            I found the light on my POS 325e would turn on if the oil was in the middle, where it's supposed to be. A little picky, but try filling the oil up to the full mark.
            :mrgreen:

            Like game music? >clicky<

            Comment


              #7
              I have one for sale if anything woo hoo.
              92 Granite Silver Vert
              M60B40 5spd

              Comment


                #8
                Originally posted by RedHoodRidah View Post
                I have one for sale if anything woo hoo.
                PM Sent

                Comment


                  #9
                  Originally posted by Ablice View Post
                  I found the light on my POS 325e would turn on if the oil was in the middle, where it's supposed to be. A little picky, but try filling the oil up to the full mark.
                  It is full. I will check again :)

                  Comment


                    #10
                    Originally posted by backtrail69 View Post
                    I had that problem on my 325is. It is on the top of the pan kickout on the driverside. Disconnect it and undo the two 10 mil bolts that hold it in place. Take it out and clean it out with some brake clean/carb cleaner. Let it dry for a few hours or overnight and reinstall. Be very careful not to drop anything in there in the process.

                    It usually takes a bit for the check code to reset with the oil level sender. Disconnecting the battery accelerates the process.
                    It doesn't depend on the battery for it to reset, just the ignition. It's a very small hole and there's a baffle to keep spirited driving from setting it off, so you'll have to give it a second if you add oil for it to turn off.

                    Comment

                    Working...
                    X